DA 2010-01: Flammable Gas Detector

 $165.00

The DA 2010 flammable gas detector actively monitors for flammable gas (LNG, LPG, Methane, Propane) giving off an audio and visual warning when the factory preset alarm level of gas has been exceeded. Used to protect against gas leaks, asphyxiation and explosions in homes around Australia.

Designed, manufactured and supported locally in Australia.

DA 2010-02: Flammable Gas Detector with External Sounder/Flasher

 $195.00

The DA 2010 flammable gas detector actively monitors for flammable gas (LNG, LPG, Methane, Propane) giving off an audio and visual warning when the factory preset alarm level of gas has been exceeded. Used to protect against gas leaks, asphyxiation and explosions in homes around Australia. The flammable gas sensor has an external output which is used to drive an external sounder flasher.

Designed, manufactured and supported locally in Australia.

DA 2010-03: Flammable Gas Detector 12-24 VDC

 $155.00

The DA 2010 flammable gas detector actively monitors for flammable gas (LNG, LPG, Methane, Propane) giving off an audio and visual warning when the factory preset alarm level of gas has been exceeded. Used to protect against gas leaks, asphyxiation and explosions in homes around Australia. The unit will need to be connected to a 12- 24 VDC source power supply. 

Designed, manufactured and supported locally in Australia.

DA 2010-04: Flammable Gas Detector 12-24 VDC (User Supplied) With Switched Output

 $175.00

The DA 2010 flammable gas detector actively monitors for flammable gas (LNG, LPG, Methane, Propane) giving off an audio and visual warning when the factory preset alarm level of gas has been exceeded. Used to protect against gas leaks, asphyxiation and explosions in homes around Australia. The flammable gas detector has a volt free external output which is used to drive external loads such as solenoid or shut off valves. The output is a SPCO relay rated 1 A.

Designed, manufactured and supported locally in Australia.

GDA 40125: Toxic / Oxygen Gas Detection Controller

The GDA 40125 Gas Detection Controller is a standalone gas detector unit with inbuilt display, sounder, flasher, relays and alarm driver. Available in the full range of GDA 2500 series electrochemical sensors which are temperature compensated and easily replaceable.

Designed, manufactured and supported locally in Australia.

GDA 40127: Carbon Dioxide Gas Detection Controller

The GDA 40127 Carbon Dioxide Gas Detection Controller is a standalone gas detector unit with inbuilt display, sounder, flasher, relays and alarm driver using an non dispersive infra red sensor.

Designed, manufactured and supported locally in Australia.

SENKO SI-100: Explosion Proof Gas Detector

SI-100 is an IEC Ex fixed gas detector installed where potential gas hazard occur to measure and monitor oxygen, toxic gas and combustible gas. Through the LCD display the SI-100 shows the concentration of gases present and the status of the unit in real time. It can be connected to a controller with a standard 4-20mA analog output communication or RS-485 digital communication. With magnetic buttons a Hot Work permit not required for calibration with no need to open the device.

IECEx Approved

GDA 4500: Single Point Gas Sampling System

The GDA 4500 is designed to be used where sensors are placed in areas that are difficult to gain access such as pits and elevated areas.

Designed, manufactured and supported locally in Australia.