Fixed Gas Detectors / Sensors
The Gas Detection Australia range of fixed gas detectors and gas sensors are manufactured to order and comprise of electrochemical sensors for toxic and oxygen sensors along with a range of infra red based sensors for Carbon Dioxide and Refrigerant gases. For volatile organic compounds(VOC's), Photo ionization methods (PID) are utilized.
GDA 4350: Carbon Dioxide Gas Sensor
The GDA 4350 is a 3 wire Non Dispersive Infra red (NDIR) Carbon Dioxide (CO₂) sensor. It gives a 4-20 mA, 0-20 mA, 0-5 V or 0-10 V o/p over the range of the sensor. Low Temperature version available.
Designed, manufactured and supported locally in Australia.
GDA 4360: Flush Carbon Dioxide Gas Sensor
The GDA 4360 is a 3 wire 4-20 mA Non Dispersive Infra red (NDIR) Carbon Dioxide (CO₂) Sensor. It gives a 4-20 mA o/p over the range of the sensor. Designed for applications where low profile intrusion into a room space is required.
Designed, manufactured and supported locally in Australia.
GDA 40127: Carbon Dioxide Gas Detection Controller
The GDA 40127 Carbon Dioxide Gas Detection Controller is a standalone gas detector unit with inbuilt display, sounder, flasher, relays and alarm driver using an non dispersive infra red sensor.
Designed, manufactured and supported locally in Australia.
SENKO SI-100C: Explosion Proof Gas Sensor
SI-100C is a IEC Ex explosion proof gas sensor ready to installed hazardous and non-hazardous areas to prevent gas hazards caused oxygen depletion, toxic gas or combustible gas. Available to detect over 25 different gas types, see Ordering Information for details.
Locally Technically Supported by Gas Detection Australia
GDA 3000: Explosion Proof (IEC Ex) Flammable / Carbon Dioxide Gas Detector
This Infra red sensor is certified for use in Zone 1 Hazardous areas within Australia.
Locally Technically Supported by Gas Detection Australia
SENKO SI-100: Explosion Proof Gas Detector
SI-100 is an IEC Ex fixed gas detector installed where potential gas hazard occur to measure and monitor oxygen, toxic gas and combustible gas. Utilising magnetic switchs so that Hot Work permit not required for calibration.
Locally Technically Supported by Gas Detection Australia
GDA 4500: Single Point Gas Sampling System
The GDA 4500 is designed to be used where sensors are placed in areas that are difficult to gain access such as pits and elevated areas.
Designed, manufactured and supported locally in Australia.
GDA 4508: Multi Point Sampling System
The GD 4508/16 is a 1 to 16 point gas sampling system for use in commercial buildings to control fresh air make up in rooms relative to external fresh air. Available for: Carbon Monoxide (CO), Oxygen (O₂) or Carbon Dioxide (CO2).
Designed, manufactured and supported locally in Australia.
GDA 5000Tx: Sampling Toxic Gas Detector
Designed to be used where areas that are difficult to gain access due to distance or toxic environment. As well as to detect greater ranges of toxic gases using advanced Pyrolyzer technology converting electrochemically inactive gases to easily detected gases.
GDA 4350 PUMP: Carbon Dioxide Gas Sampling System
Discontinued Product
The GDA 4350 Pump is designed to be used where diffusion sensors are impractical due to environmental or wash down requirements. An advanced 3 wire Non Dispersive Infra red (NDIR) Carbon Dioxide sensor giving a 4-20 mA, 0-20 mA, 0-5 V or 0-10 V o/p over the range of the sensor. Low Temperature version available.
Designed, manufactured and supported locally in Australia.