SENKO SI-100: Explosion Proof Gas Detector

SI-100 is an IEC Ex fixed gas detector installed where potential gas hazard occur to measure and monitor oxygen, toxic gas and combustible gas. Through the LCD display the SI-100 shows the concentration of gases present and the status of the unit in real time. It can be connected to a controller with a standard 4-20mA analog output communication. With magnetic buttons a Hot Work permit not required for calibration with no need to open the device.

IECEx Approved

SENKO SI-100C: Explosion Proof Gas Sensor

SI-100C is a IEC Ex explosion proof gas sensor ready to installed hazardous and non-hazardous areas to prevent gas hazards caused oxygen depletion, toxic gas or combustible gas. Available to detect over 25 different gas types, see Ordering Information for details.

IECEx Approved

GDA 2000Ex: Explosion Proof (IEC Ex) Flammable Gas Detector

The GDA 2000Ex is certified for use in Zone 1 Hazardous areas within Australia.

FULLY TECHNICALLY SUPPORTED by GAS DETECTION AUSTRALIA.

IECEx Approved

GDA 2000Tx: Explosion Proof (IEC Ex) Toxic and Oxygen Gas Detector

This gas detector/gas sensor is certified for use in Zone 1 Hazardous areas within Australia.

FULLY TECHNICALLY SUPPORTED by GAS DETECTION AUSTRALIA.

IECEx Approved

GDA 2000VOC: Explosion Proof (IEC Ex) Flammable Volatile Organic Compound Gas Detector

The GDA 2000VOC is an explosion proof (IEC Ex) certified VOC gas detector using PID technology as means of detection.

FULLY TECHNICALLY SUPPORTED by GAS DETECTION AUSTRALIA.

IECEx Approved

GDA 3000: Explosion Proof (IEC Ex) Flammable / Carbon Dioxide Gas Detector

This Infra red sensor is certified for use in Zone 1 Hazardous areas within Australia.

FULLY TECHNICALLY SUPPORTED by GAS DETECTION AUSTRALIA.

IECEx Approved