Nitrogen Dioxide (NO₂) Gas
Nitrogen dioxide (NO₂) is a nasty-smelling gas, and is an acidic and highly corrosive gas that can affect our health and environment.
In poorly ventilated situations, indoor domestic appliances such as gas stoves and gas or wood heaters can be significant sources of nitrogen dioxide.
Elevated levels of nitrogen dioxide can cause damage to the human respiratory tract and increase a person's vulnerability to, and the severity of, respiratory infections and asthma. Long-term exposure to high levels of nitrogen dioxide can cause chronic lung disease. It may also affect the senses, for example, by reducing a person's ability to smell an odour. High levels of nitrogen dioxide are also harmful to vegetation damaging foliage, decreasing growth or reducing crop yields. Nitrogen dioxide can fade and discolour furnishings and fabrics, reduce visibility, and react with surfaces.
© The State of Queensland 2018
Safe Work Australia Exposure Standards
8 Hour Time Weighted Average |
3 ppm |
15 Minute Short Term Exposure Limit |
5 ppm |
More Infomation © Commonwealth of Australia 2018
GDA 2527: Nitrogen Dioxide Gas Sensor
The GDA 2527 Nitrogen Dioxide (NO₂) Gas Sensor is a 2 wire 4-20 mA Loop Powered device with a range of 0-30 ppm Nitrogen Dioxide. It has an electrochemical sensing unit which is temperature compensated and easily replaceable.
Designed, manufactured and supported locally in Australia.
GDA 2627: Nitrogen Dioxide Gas Sensor with Voltage Output
The GDA 2627 Nitrogen Dioxide gas sensor is a further enhancement of the GDA 2527 Nitrogen Dioxide gas sensor that allows AC and DC operation. It has an electrochemical gas sensing unit which is temperature compensated and easily replaceable.
Designed, manufactured and supported locally in Australia.
GDA 40125: Toxic / Oxygen Gas Detection Controller
The GDA 40125 Gas Detection Controller is a standalone gas detector unit with inbuilt display, sounder, flasher, relays and alarm driver. Available in the full range of GDA 2500 series electrochemical sensors which are temperature compensated and easily replaceable.
Designed, manufactured and supported locally in Australia.
SENKO SI-100: Explosion Proof Gas Detector
SI-100 is an IEC Ex fixed gas detector installed where potential gas hazard occur to measure and monitor oxygen, toxic gas and combustible gas. Through the LCD display the SI-100 shows the concentration of gases present and the status of the unit in real time. It can be connected to a controller with a standard 4-20mA analog output communication. With magnetic buttons a Hot Work permit not required for calibration with no need to open the device.
SENKO SI-100C: Explosion Proof Gas Sensor
SI-100C is a IEC Ex explosion proof gas sensor ready to installed hazardous and non-hazardous areas to prevent gas hazards caused oxygen depletion, toxic gas or combustible gas. Available to detect over 25 different gas types, see Ordering Information for details.
GDA 2000Tx: Explosion Proof (IEC Ex) Toxic and Oxygen Gas Detector
This gas detector/gas sensor is certified for use in Zone 1 Hazardous areas within Australia.
FULLY TECHNICALLY SUPPORTED by GAS DETECTION AUSTRALIA.
GDA 5000Tx: Sampling Toxic Gas Detector
Designed to be used where areas that are difficult to gain access due to distance or toxic environment. As well as to detect greater ranges of toxic gases using advanced Pyrolyzer technology converting electrochemically inactive gases to easily detected gases.
SENKO SGT: Disposable Portable Single Gas Detector
The SENKO SGT is a low cost disposable sensor, guaranteed 2 years operating life without recharging or calibration required.