Hydrogen Sulphide (H₂S) Gas
Hydrogen sulfide is the chemical compound with the formula H2S. It is a colorless chalcogen hydride gas with the characteristic foul odor of rotten eggs. It is very poisonous, corrosive, and flammable. Hydrogen sulfide is often produced from the microbial breakdown of organic matter in the absence of oxygen gas, such as in swamps and sewers; this process is commonly known as anaerobic digestion which is done by sulfate-reducing microorganisms. H2S also occurs in volcanic gases, natural gas, and in some sources of well water. The human body produces small amounts of H2S and uses it as a signaling molecule.
Safe Work Australia Exposure Standards
8 Hour Time Weighted Average |
10 ppm |
15 Minute Short Term Exposure Limit |
15 ppm |
More Infomation © Commonwealth of Australia 2018
GDA 2529: Hydrogen Sulphide Gas Sensor
The GDA 2529 Hydrogen Sulphide gas sensor is a 2 wire 4-20 mA loop Powered device with a range of 0-50 ppm Hydrogen Sulphide. It has an electrochemical sensing unit which is temperature compensated and easily replaceable.
Designed, manufactured and supported locally in Australia.
GDA 2629: Hydrogen Sulphide Gas Sensor with Voltage Output
The GDA 2629 Hydrogen Sulphide gas sensor is a further enhancement of the GDA 2529 Hydrogen Sulphide gas sensor that allows AC and DC operation. It has an electrochemical gas sensing unit which is temperature compensated and easily replaceable.
Designed, manufactured and supported locally in Australia.
GDA 40125: Toxic / Oxygen Gas Detection Controller
The GDA 40125 Gas Detection Controller is a standalone gas detector unit with inbuilt display, sounder, flasher, relays and alarm driver. Available in the full range of GDA 2500 series electrochemical sensors which are temperature compensated and easily replaceable.
Designed, manufactured and supported locally in Australia.
SENKO SI-100: Explosion Proof Gas Detector
SI-100 is an IEC Ex fixed gas detector installed where potential gas hazard occur to measure and monitor oxygen, toxic gas and combustible gas. Through the LCD display the SI-100 shows the concentration of gases present and the status of the unit in real time. It can be connected to a controller with a standard 4-20mA analog output communication. With magnetic buttons a Hot Work permit not required for calibration with no need to open the device.
SENKO SI-100C: Explosion Proof Gas Sensor
SI-100C is a IEC Ex explosion proof gas sensor ready to installed hazardous and non-hazardous areas to prevent gas hazards caused oxygen depletion, toxic gas or combustible gas. Available to detect over 25 different gas types, see Ordering Information for details.
GDA 2000Tx: Explosion Proof (IEC Ex) Toxic and Oxygen Gas Detector
This gas detector/gas sensor is certified for use in Zone 1 Hazardous areas within Australia.
FULLY TECHNICALLY SUPPORTED by GAS DETECTION AUSTRALIA.
GDA 5000Tx: Sampling Toxic Gas Detector
Designed to be used where areas that are difficult to gain access due to distance or toxic environment. As well as to detect greater ranges of toxic gases using advanced Pyrolyzer technology converting electrochemically inactive gases to easily detected gases.
SENKO SGT: Disposable Portable Single Gas Detector
The SENKO SGT is a low cost disposable sensor, guaranteed 2 years operating life without recharging or calibration required.
SENKO MGT: Portable Multi-Gas Detector
MGT is a Portable Multi-Gas Detector engineered for personal protection and use in confined spaces detecting Oxygen (O₂), Hydrogen Sulphide (H₂S), Carbon Monoxide (CO) and Combustible Gases
