GDA 3160 : Flush Mount Refrigerant Gas Detector

The GDA 3160 is a low profile wall mounted refrigerant detector for use in offices and laboratories where a gas sensor needs to appear non obtrusive. The sensor uses the lastest in NDIR techniques for detecting a wide range of refrigerant gases and is therefore immune from cross sensitivity to other gases.

Designed, manufactured and supported locally in Australia.

GDA 4360 : Flush Carbon Dioxide Gas Sensor

The GDA 4360 is a 3 wire 4-20 mA Non Dispersive Infra red (NDIR) Carbon Dioxide (CO₂) Sensor. It gives a 4-20 mA o/p over the range of the sensor. Designed for applications where low profile intrusion into a room space is required.

Designed, manufactured and supported locally in Australia.

GDA 7228 : Flush Mount Oxygen Gas Sensor

The GDA7228 Flush Mount Oxygen gas sensor is a 2 wire 4-20 mA Loop Powered device with a range of 0-25% vol Oxygen.

Designed, manufactured and supported locally in Australia.

GDA 4011 : Flush Mount Single Channel Gas Detection Controller

This is a flush wall mounted (Clipsal GPO) single channel control unit. It interfaces to all the GDA a series of 4-20mA sensors. There are 3 relay o/p’s, Alarm 1, 2, and fault. These relays are SPCO. The backlit LCD display indicates current gas concentration and alarm status. There is an internal sounder which can be muted from the front panel. The unit requires 24v dc.

Designed, manufactured and supported locally in Australia.

GDA 74001 : Extended Mimic Panel

The GDA 74001 is a low profile flush wall mounted mimic panel. These units are used on multi entry rooms so that users may view the gas levels and alarm status of each entry point for entering the room The 74001 is used in conjunction with the GDA 4080 control unit.

Designed, manufactured and supported locally in Australia.